Sign Sleeves for Plasticade Type I and II Folding Barricades
Add a sign to your Plasticade Type I and II barricades with the Sign Sleeves for Plasticade Type I and II Folding Barricades.
-
PRODUCT ID: RSPB1PPPLZSIGNSL(XX)(X)
-
Color (XX): (WH) White | (OR) Orange
-
Installation (X): (I) Pre-Installed on Plasticade Type 1 or 2 Barricade at time of order. | (U) Un-installed to add to existing Plasticade Type I or II Barricades.
-
Plasticade Type I and II Folding Barricades are NCHRP-350 Accepted for use as a sign stand with this sign sleeve.
-
Compatibility: For use with Plasticade Type I or II Folding Barricade only, with signs up to 48" x 48" made of lightweight aluminum composite material.
-
Hardware: Included to mount 1 sign sleeve to plasticade barricade.
A barricade is a portable or fixed device having from one to three rails with appropriate marking and is used to control road users by closing, restricting, or delineating all or a portion of the right-of-way. Refer to the MUTCD for more information.
-
Type 1 Barricades may be used on conventional roads or urban streets.
-
Type 2 Barricades should be used on freeways and expressways or other high-speed roadways.
-
Type 3 Barricades should be used to close or partially close a road.
-
Red/White Stripes: When barricades are used to warn road users of the end of a roadway, the stripes shall be red and white.
-
Sign Placement: Signs mounted on barricades and barricade/sign combinations shall be crashworthy.
The MUTCD (Manual for Traffic Control Devices) specifies sizes and color combos for Barricade Boards and Vertical Panels. Refer to the MUTCD for more information.
-
4" Stripes: boards/panels that are 8-12" x 24" and smaller shall have 4" Stripes
-
6" Stripes: boards/panels that are 8-12" x 36" and larger shall have 6" Stripes
-
Red/White Stripes: STOP or Prohibition (Permanent)
-
Orange/White Stripes: indicate Temporary Traffic Control
-
NOTE: Barricade sheeting can NOT be rotated for use as both "left" and "right". There is a common misconception that "ALL" striped goods can be used for both "right" and "left" options by simply rotating them 180 degrees. Shown Below: Rotate the "right" object marker -or- barricade board and it remains a "right".
